Change Collector
Change Collector
3D
Published 2018-01-29T11:47:15+00:00
A simple extension to a can that allows you to store your spare change. The middle cage like design allows you to watch the coins spin down the ramp while also watching the pile of change grow. For any spare dollars you can simply pushed it through the can's normal opening on top. There are two forms of this print but both same design one of them just has a longer ramp.
To Assemble:
1st Print and remove the supports of the 3D model
2nd Cut the can in two pieces (it is best to cut the can close to the top)
3rd Twist the two pieces of the can into the slots on the top and bottom of the 3D print
4th Start filling the can up with coins!
Have the layer height at .1 or .2 for better quality (will take longer)
I would print at infill of 10% (I've tried 10% and 30% before but they both felt the same)
Have the support density between 10-20% to deal with less with supports and faster build time
Have the support Z distance between .2 - .3 for easyer support removal
| Date published | 29/01/2018 |
| ¿Cuándo tiempo lleva? | 150 - 210 minutos |
| Tecnología | FDM |
| Complejidad | Fácil |