Coronavirus / COVID-19 Pin
1,184
visitas
24
descargas
0 comentarios
Cargando comentarios...
Coronavirus / COVID-19 Pin
3D
Published 2020-06-16T20:00:14+00:00
3
0
Add to Collection
Descripción
There isn't too much to explain here. Wear this pin for whatever reason. Personally, I think it just looks cool and it's not a difficult print. After you print it, use some glue to adhere a pin back into the depression on the back of the model. E6000 works well for this but hot glue is also sufficient. It's also good to score both the model and the pin before you glue them together for added adhesion.
Licencia
Detalles de impresión
Print this at 100% infill and any layer height you prefer; however, a small layer height makes the model look a little better. Additionally, if you have one, I would recommend using a small nozzle to make the front look really clean.
Información técnica
Date published | 16/06/2020 |
¿Cuándo tiempo lleva? | 15 - 16 minutos |
Sin apoyo | YES |
Más información
Archivos