Cover for Male XT60 connector
Cover for Male XT60 connector
3D
Published 2020-05-19T16:08:05+00:00
I struggled to find a cover for a male XT60 connector (or XT60E, in my case). So I designed this one. It is easy to install and remove. Prevent dangerous short circuits when a male XT60 connector is not in use but still connected power. NOTE: I am using it on my Creality Ender 2 PSU, with an output voltage of 12 V. Use it at your own risk, your filament's dielectric properties may be different.
Prints without supports.
I was too lazy to measure the connectors myself (besides, they were already installed when I decided to make the cover), so I used this model by Simon Hersche as reference
I printed it with 0.16 or 0.12 mm layer height because it was a batch print with other stuff, but 0.2 mm should be just fine.
Infill: 10%
| Date published | 19/05/2020 |
| ¿Cuándo tiempo lleva? | 12 - minutos |
| Cantidad de filamento | 1 |
| Dimensiones | 8.1 x 15.7 x 23.8 mm |
| Sin apoyo | YES |
