Decorative Birdhouse Pack
$5.00 Decorative Birdhouse Pack
3D
Published 2023-03-09T09:58:10+00:00
Kick off your lawn and garden projects with these beautiful print-in-place birdhouses. All three birdhouses are included.
All three print in place without supports. Keyholes on the back make hanging them easy. The openings are sized at 1 1/4 inch for smaller song birds. The space inside is on par with recommendations made by the Ogden Nature Center. These scale up or down well so you can resize for your specific needs. Just be aware that the keyholes will change size as well.
Clean out doors located on the bottom make for easy access. Small divots in the door and bottom of the house give the option of using 6mm by 2mm magnets to hold the door in place. Magnets are not required as the doors have a flange that hold them in place but they do make a very nice option.
The door file also prints without supports and works with all four houses.
Recommended magnets here: https://www.amazon.com/dp/B07KJ9H31P/ref=cm_sw_r_apin_dp_WSMY74Y2MDQEB70CY3MG
No supports
I use:
.4 or .6 nozzle
3 perimeters is best but 2 will work
10% infill
.2 or .3 layer height
| Date published | 09/03/2023 |
| Precio | $5.00 |
| Sin apoyo | YES |