Enclosure Exhaust - (120mm fan, 4" dryer duct)
3,503
visitas
125
descargas
2
colecciones
0 comentarios
Cargando comentarios...
Enclosure Exhaust - (120mm fan, 4" dryer duct)
3D
Published 2019-04-29T17:29:40+00:00
16
0
Add to Collection
Descripción
This exhaust system connects to common 4" dryer vent ducting. The fan grill/ air straightener part stops the fan from stirring the enclosure air.
There is a groove on the hose side part is to help keep the cable tie in place that holds the hose.
You can connect the vent hose directly to the fan side part if you want and not use the hose side part. I made the hose side connector so that I could easily remove the hose and/or attach it to my other printer depending on which was printing something that needs be sent outside.
Detalles de impresión
Straightener (square block) printed with 5 perimeters, 7% honeycomb infill and no top or bottom layers.
Información técnica
Date published | 29/04/2019 |
Tecnología | FDM |
Complejidad | Fácil |
Sin apoyo | YES |
Más información
Archivos