Ender 3 glass bed clips cr-6 style
3,955
visitas
265
descargas
0 comentarios
Cargando comentarios... 
Ender 3 glass bed clips cr-6 style
3D
Published 2020-12-15T14:00:16+00:00
33
0
Add to Collection
Descripción
I like how the bed is held in place on the CR-6 SE so I wanted that on my ender 3 as well.
The clips are attached to the bed, so you cannot loose them and only cover the build plate the bare minimum.
You will need per clip a M3x20 bolt, an M3 nut and a 10mm spring. Since I replaced my original springs with yellow ones, I cut two of the original springs in half. The yellow springs push against the brackets at the same height where they push against the screw, so there's no additional compression of the spring. I suggest to print this in PETG or another material that can tolerate higher temperatures.
Información técnica
| Date published | 15/12/2020 |
| Sin apoyo | YES |
Más información
Archivos