Eva-Dry E-333 Rechargeable Dehumidifier/Desiccant Mount
Eva-Dry E-333 Rechargeable Dehumidifier/Desiccant Mount
Published 2019-03-11T11:41:30+00:00
I made this mount specifically for the Eva-Dry E-333 I use in my filament dry box. I really like this unit as it is easy to recharge and tends to last a few months between charges at least where I live. I wanted something that was going to hold the unit so that it would not bounce around the box and so it would always be visable (assuming I do not cover the window in it with tall spools like in the photo) from the outside when it was time to re-charge the unit.
There are two versions, one with holes for mounting with bolts or screws, and one for mounting with double sided tape.
Instructions for filament dry box mounting
Supplies
- EvaDry-mount-bolts printed
- 4 bolts. The holes are sized for M3 or any similar size.
- 4 nuts that match your bolts
- 4 washers (preferably fender washers) that match your bolts
- Tools to tighten your bolts
- Hold the bracket up to where you would like to mount it inside your box and, using a marker, mark the 4 holes on the box
- Using a 1/16" or 1.5mm drill bit slowly drill a small pilot hole through each dot you marked (starting small will help prevent cracking the plastic tub)
- Using a 1/8" or 3mm drill bit slowly drill out each hole to the desired size
- Insert the screws through the part and then through the side of the bin.
- Put the washer over the bolt on the outside of the bin and then secure with nut.
Instructions for tape mounting
Supplies
- EvaDry-mount-double-sided-tape printed
- Foam double sided tape (like this 3M tape)
- Stick tape to the indents on the back of the mount and cut to length
- Stick to desired surface
Date published | 11/03/2019 |
Tecnología | FDM |
Sin apoyo | YES |
Thanks for the print. Setting up my dehumidifier with the EvaDry in a clear storage container. Exactly what I needed. Thank you.