FCX24 Flat Skid for Micro Komodo Conversion
FCX24 Flat Skid for Micro Komodo Conversion
3D
Published 2022-08-22T09:31:47+00:00
This conversion is not for the faint of heart and you will lose the 2-speed transmission in the FCX24. It requires cutting out the stock skid and drilling four holes in the stock chassis. However, when you're done you have a very clean setup that performs very well.
1. Remove the stock motor/transmission, ESC/RX, battery, shift servo, and shift linkage.
2. Cut out the stock skid and file/sand the inside of the chassis rails smooth.
3. Screw the drill guide into one side of the chassis using the upper link screws. Drill holes with a 1.7mm bit.
4. Remove the drill guide and repeat on the other side.
5. Test the new holes on both sides and self-tap using M2*4mm screws.
6. Attach the new skid using (4) M2*4mm screws.
7. Mount the Micro Komodo/mount/transmission to the skid.
8. Route the motor wires and install the battery divider using the stock screws for the shift servo.
9. Finish the install (ESC, RX, etc.).
- PETG recommended
- 15%+ infill
- 4 count shell recommended
| Date published | 22/08/2022 |