Flashforge Adventurer 4 (Maybe 3) Extruder Nozzle Clips
Flashforge Adventurer 4 (Maybe 3) Extruder Nozzle Clips
Published 2023-02-20T17:00:56+00:00
So, I got about 8 months of print time on my AD4 3D printer. I started to get a lot of nozzle errors where it stopped print jobs on me. I contacted support but the extruder parts only have a 3 month warranty. All the online sites are sold out of these nozzle clips. So, I grabbed my calipers and went to work on these little clips. I went thru about 3 iterations of this making some small adjustments here and there. Here is the final outcome.
Important: Disconnect the extruder housing filament tube and ribbon cable, then remove the extruder housing completely from the gantry (Its super easy, just two screws and will make this so much easier for you. Do not drop the screws into the bed trenches *The-Upside-Down*).
Note: The levers that connect and hold the nozzle have a better fill tolerance than the OEM clips. These will minimize nozzle movement when the filament extrudes, then retracts. I had a hard time getting the hole where these sit within the extruder housing, to fitting perfect, and didn't want to mess with the model any further so I made the holes slightly too small. I used a deburring tool on the inside of the large hole to make it slightly bigger. Taking a little off at a time and checking the fit each time I removed a bit more filament from the model. Be careful making the hole too big, as too much play will allow the nozzle to wiggle a bit more than it should. You want it to be snug, but with no resistance when you move the clip back and fourth without the spring inserted. Once the fit is right, install the spring, install the cover and make sure your nozzle locks in securely and can easily removed before you re-install the extruder onto the gantry.
Layer Hieight: 0.12
Initial Layer Height: 0.12
Wall Thickness: 1.2
Wall Count: 4
Infill: 100%
Infill Pattern: Tri-Hexagon / Honeycomb
Nozzle Temp: 220c
Build Plate Temp: 50c
Flow: 100%
Print Speed: 25.0 mm/s
Wall Speed: 12.5 mm/s
Initial Layer Speed: 20.0 mm/s
Z hop speed: 5 mm/s
Number of slower layers: 2
Retraction: Enabled
At Layer Change: Enabled
Retration Distance: 5mm
Retraction Speed: 45 mm/s
Z-Hop When Retracted: Enabled
Z-Hop Height: 0.2mm
Regular Fan Speed: 50%
Max Fan Speed: 100%
Initial Fan Speed: 50%
Regular Fan Speed: At layer 3 or 4
Supports: I manually placed supports under the Levers (the arms that touch and hold the nozzle) you can probably get away with auto supports.
Adhesion: None - I have a heated glass bed on my Ender 3 Pro. Use at your descretion.
Special Modes: Arc Welder (Not available for Flash Print)
Date published | 20/02/2023 |
¿Cuándo tiempo lleva? | 1 - 2 minutos |
Tecnología | FDM |
Sin apoyo | YES |