Flexy Print In Place Baby Jumping Spider
$3.18 Flexy Print In Place Baby Jumping Spider
3D
Published 2023-11-07T04:42:40+00:00
The Pack Includes All New ''Cute Baby Jumping Spider'' Comes With a Magical "Spider Web"
Captive Magnets Are Available in Both Web & The Spider, So You Can Play Around With Either Sticking The Spider to The Web or any Metallic Surface, You'll Definitely Enjoy It
* Make Sure To Add A Pause In Slicer Just a Layer Or Two Before, Where the Caps Closes For Captive Magnets, So you Can Resume after you Place the Magnets
* While Adding Magnet During the Pause Make Sure to Verify The Correct Magnetic Poles (North/South)
The Models is Already Been Designed to Perfectly Fit a 10x3mm Magnet, So It is Possible to Increase the Size, but Decreasing It Will Result in a Slightly Smaller Slot for the Magnet.
Just Slice it And print it, A Good Bed Adhesion is a must in order to Make A successful print
I did make sure that design is fully compatible for printing without supports
Feel free to share your makes on this page, Or Tag me On My Socials
TikTok- tiktok.com/@printverse_designs
Instagram- instagram.com/printverse_crafts
Twitter- twitter.com/Printverse1
Thank you.
The Printverse Designs are protected by Copyright Law. When you purchase, You Do Not have the right to sell any digital file or printed model without any consent
You can obtain commercial licence to sell physical Prints from this link
patreon.com/printverse
-No Supports Required
-Print-in-place
-10-20% infill is good to go
-PLA works great
| Date published | 07/11/2023 |
| Precio | $3.18 |
| Sin apoyo | YES |