Headphone hanger (or coats / others)
1,005
visitas
14
descargas
0 comentarios
Cargando comentarios... 
Headphone hanger (or coats / others)
3D
Published 2020-10-25T17:10:16+00:00
1
0
Add to Collection
Descripción
The back of the hanger contains a hole that you can slot over a screw. Make sure to leave the screw about 2MM out of the wall (you can do it by feel too, should be a really snug fit for it to not rotate).
Licencia
Detalles de impresión
I did 100% infill with support from buildplate for the overhang, but you don't need 100% for it to be strong enough, I'd say 20% should be enough for most uses.
Información técnica
| Date published | 25/10/2020 |
| ¿Cuándo tiempo lleva? | 33 - minutos |
| Dimensiones | 50mmx15mmx23mm |
Más información
Archivos
