Hollow Table
Hollow Table
3D
Published 2019-07-08T15:34:10+00:00
"Hollow Table"
I thought that hollow patterns on top of the model are impossible. But I was wrong. After many hours of 3D modeling I figure out how to control every single line of filament printed in each layer. This gives unique opportunity to visually draw each line that is printed exactly as I need to. With start/end points almost under total control.
Special 3D modeling technique was used to make this model. I know this hollow pattern can be printed up side down without any trouble. But this model can be printed as a table WITHOUT SUPPORTS.
Set Slice Gap Closing Radius to 0.001mm (distance between edges of objects polygons) otherwise the slicer will count it as a solid surface and not single lines.
ALL layers 0.2mm (also first layer)
Speed.. as your printer can do. Its all about bridges
| Date published | 08/07/2019 |
| Sin apoyo | YES |
