Impeller
3,321
visitas
84
descargas
0 comentarios
Cargando comentarios...
Impeller
3D
Published 2015-02-16T08:27:38+00:00
4
0
Add to Collection
Descripción
The three components you are viewing makeup the upper part of a pump. All components use standard SAE size O-rings. Sealing has been tested, as well as the pump. It is not a high-flowrate pump. It is sized for a standard hobby motor. You will need some sort of sleeve to fit into the pump housing in order to tighten the clearances so the pump will work. It was originally designed to bolt to the side of a tank. I cannot remember what size O-rings I used, but they were almost all 200 series.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 38 g of filament and takes 339 minutes.
Información técnica
Date published | 16/02/2015 |
¿Cuándo tiempo lleva? | 339 - 349 minutos |
Cantidad de filamento | 38 g |
Dimensiones | 77 x 59 x 44 mm |
Más información
Archivos