Insulation Load Spreading Retaining Washer
1,362
visitas
56
descargas
0 comentarios
Cargando comentarios...
Insulation Load Spreading Retaining Washer
3D
Published 2020-11-24T11:25:34+00:00
2
0
Add to Collection
Descripción
Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
Licencia
Detalles de impresión
### Supports
no
### Resolution
0.3
### Infill
20
### Misc Notes
Print without supports by moving 1mm below the build plate (z-axis -1mm).
Información técnica
Date published | 24/11/2020 |
¿Cuándo tiempo lleva? | 25 - minutos |
Más información
Archivos