LED icicles Christmas decoration
LED icicles Christmas decoration
3D
Published 2018-12-17T17:04:01+00:00
I found a great looking icicle model and decided to remix it so that I can put LEDs inside and hang it as Christmas decoration.
I've incorporated a nut at the base of the icicle and the LED goes on top of a screw. I've also designed a special channel in the screw itself, which should prevent any rain from coming in, so they should be safe to hang outside. I've tested it out by pouring 2L (half a gallon) of water over it and none of it made its way inside.
I've made a video about the design and build process, you can watch it here: YouTube video link.
Attributions:
The icicle was remixed from a model by faberdasher.
The nut and screw were remixed from models by YSoft_be3D.
The hook was remixed from a model by renobot.
Print the icicle in two modes; the screw part can be printed at 0.2mm layers and the icicle itself is best done in vase mode. Some slicers, like Simplify3D, let you easily change printing mode.
You don't need any supports for the icicle or the screw. You should add a small support pillar at the base of the hook (check video if you want to see where exactly), but you don't need any supports if you decide to use the ring hook.
| Date published | 17/12/2018 |
| Sin apoyo | YES |