Microphone Shock Mount for Ikea TERTIAL
Microphone Shock Mount for Ikea TERTIAL
3D
Published 2020-11-20T16:37:32+00:00
I've designed this shock mount for Trust Madell microphone, but it can easily be used with other ones. You may just need to use a different rubber bands, bungie cord or whatever you need.
Shock mount connects to arm form an Ikea TERTIAL desk lamp. I have found that having two spings on the upper arm is too much tension and the mic constantly goes up, so removing one of them fixes the issue.
The shock mount is split up to multiple pieces to avoid tons of supports while printing.
I've printed mine in PRINT-ME black PET-G on my custom CoreXY at 0.2mm. It only reqires a small support when printing holes for screws or hex nuts.
What you'll need (you could use different blot lenghts or bands - this is just what I had on hand and it works nicely):
- M3x16mm screw - 6 pcs.
- M3x12mm screw - 2 psc.
- M3 nut - pcs.
- hair bands roughly 35mm in diameter - 6 pcs.
- straight pieces of 1.75mm filament cut to about 9-10mm in lenght - 12 pcs.
ASSEMBLY
It's pretty straight forward and you can see everything in the pictures, but I'll give you some tips.
Pillars have 3 holes on both ends. The middle one needs to be tapped with M3 tap and the outside ones may need to be cleaned up with a 2mm drill bit.
The rings have holes for M3 screws and 2 small holes on either side of them. Here you'll need to press in the small pieces of filament. They should be protruding about 3-4 mm above the sufrace of the ring. They will help you with the assembly and ensure that pillars won't rotate.
Use the 12mm screws on a pillar that has a lamp mounting part.
Mount the whole thing to the arm using 16mm screws - the ones that are in the lamp are too shot.
| Date published | 20/11/2020 |