Modular drawer divider
1,220
visitas
2
colecciones
3 comentarios
Cargando comentarios...
$4.00 Modular drawer divider
3D
Published 2023-01-31T10:31:02+00:00
16
3
Add to Collection
Descripción
Would you like to support my work? :)
Check out my full catalogue with exclusives, early access and commercial licences.
A modular drawer divider suited for many different use cases. You can configure the parts to fit your needs and drawers perfectly. The parts are fast to print and use very little material.
The connectors of the dividers can hold up to 4 parts and you can create every possible compartment composition. The connectors to not add to leigh so measuring what parts you need is quite easy.
How it works
- Measure your drawer and make a little sketch of the size and setup of parts you want to print (I included a showcase sketch in the pictures)
- Find out which height you want to use (either 11 or 8 cm)
- Make a list of the parts you need (available parts can be found below)
- Print the parts and for every connection point two of the connectors
- Assemble the parts and connectors and place them in your drawer
- If you have an odd size like 40.5 cm – use extra connectors at the end of your assembly to add to length below two centimeters
List of parts (height x width)
- H8W2
- H8W3
- H8W4
- H8W5
- H8W7
- H8W10
- H8W15
- H8W20
- H11W2
- H11W3
- H11W4
- H11W5
- H11W7
- H11W10
- H11W15
- H11W20
- Universal Connector
Detalles de impresión
- Required build volume: depends on what part you want to print
- Material usage example: H8W10: 10g
- This design needs a decent print bed adhesion. Depending on your bed type measures like slowing down the first layer, increasing initial layer print temperature, increasing the first layer height, cleaning the bed with isopropyl alcohol or bed leveling may help. With a generally well set up printer the design is easy to print. If nothing else helps a brim can be used.
- Material: PLA
- Print direction: stls are rotated correctly (check images)
- Support: none
- Nozzle size: 0,4 mm
- Line width: 0,4 mm
- Layer height 0,2 mm
- Outer walls: 3
- Infill: 15%
- Build plate adhesion type: none
Información técnica
| Date published | 31/01/2023 |
| Precio | $4.00 |
| Sin apoyo | YES |
Más información
Archivos