Packable Board Game Token / Components Organiser
Packable Board Game Token / Components Organiser
3D
Published 2020-05-26T16:35:32+00:00
Packable trays and case for board game tokens and cards. Really easy to print and you can even decide to add magnets to it if you really like it.One rubber band is needed to keep it all together, please check all the photos in gallery/preview.The print consists of two large cases that also act as token holders and are great as deck holders or discard piles. These large cases stores 6 smaller trays, I have included two styles of these small trays, the "Curved Dish" is a standard tray that you can easily slide tokens in and out, and there is also the "Card Holder Dish" which has limited storage for tokens and can hold big clumps of playing cards. I would recommend printing four curved dishes and two card holder dishes. This print requires a rubber band to keep the trays together as shown in the photos. No supports needed.Please don't hesisitate to message me.
You need to print 6 dishes, they consist of curved dishes and card holder dishes.I would recommend printing four curved dishes and two card holder dishes.
Each small tray takes around 2 hours to print at 0.2600mm layer height.
You then need to print 2 cases.
Each large case takes around 6 hours to print at 0.2600mm layer height, 2 cases are required to finish the set.
Please check all the photos in gallery to get a clear idea on what to print.
| Date published | 26/05/2020 |
| ¿Cuándo tiempo lleva? | - 960 minutos |
| Dimensiones | 960mm x 139.70mm x 32.00mm |
| Sin apoyo | YES |