Poker Chip Tray/Rack Stackable 3 Sizes - Based on Official Design
Poker Chip Tray/Rack Stackable 3 Sizes - Based on Official Design
3D
Published 2021-11-29T10:38:09+00:00
These Poker Chip Trays are based on the same design and exact dimensions of the universally used acrylic chip trays.
I have included 2 additional sizes, a 4-rack and a 3 rack that are also stackable.
I have a Photon SE and the 3-Rack is the only one that I can viably print with a small resin printer plate, but others with PLA printers may have the free space to make a full size tray, have at it and tell me the results!
I'll update these as I refine the design.
You can print the 3-rack either level or tilted up to 52 degrees on a Photon Mono SE plate. Level takes the least time and requires the shortest supports, therefore less material is used, and I like the sanding cleanup with as few supports as possible. But make sure you support your flat edges enough to avoid warping the whole edge.
| Date published | 29/11/2021 |