After realizing that other items, similar to this one, require too much elbow grease after print work, I wanted to design a new one, as a print in place and assemble. No additional processing is required.

After all, the Alpha and Beta testing we finally managed to find the best design for the print and assemble mantra.

After your print is done and if your printer is tuned, you should be able to assemble everything without any effort. After it, is assembled just put a toothpick through holes in the gear and shaft to lock them in place. Cut out the rest of the toothpick and it should all work like a charm right from the start.

If anyone is interested in commercial use please contact me.

Updated Alpha Version 1.5:
- Kit: was arranged for easy print on most common printers
- Pull Stick: was updated, lowered, and changed teets
- Cap Threaded: was scaled to better fit
- Propeller: completely redesigned for better flight
- Handle: islands between fingers filed down for a nicer grip
- Gear: completely redesigned for a better grip with a pull stick
- Shaft: scaled for a better fit
- Shaft Bearing: finer sides

Updated Alpha Version 1.6:
- Kit: No change
- Pull Stick: No Change
- Cap Threaded: Changed name. Called only "Cap" now
- Propeller: completely redesigned for easier print
- Handle: Figers positions rearranged for better grip, Initials moved to the bottom of the handle, Back side flattened together with thread, so no supports are needed at all anymore.
- Gear: No Change
- Shaft: Joined with "Shaft Bearing" and now called only "Shaft"
- Shaft Bearing: Joined with "Shaft" and now called only "Shaft"

Updated Alpha Version 1.6 to BETA 1.6.1:
- Kit: No change
- Pull Stick: Small scale for an easier fit
- Cap: Small scale for an easier fit
- Propeller: No change
- Handle: Slight changes for better print finish
- Gear: Added hole to insert a toothpick to lock the gear in place
- Shaft: Added hole to insert a toothpick to lock the gear in place

Updated to BETA v1.6.2:
- Kit: Cap was removed since it is causing more issues than it solves
- Pull Stick: No change
- Cap: Removed
- Propeller: Scaled up for more flight
- Handle: Slight changes for better grip and thread removed
- Gear: Toothpick hole scaled up slightly
- Shaft: Toothpick hole scaled up slightly

Official Release Version 2.0 is available from the 21st of March 2023.
- Kit: No Changes
- Pull Stick: No Change
- Propeller: No Changes
- Handle: Change was done on the top, where the shaft is placed. We removed the cap and changed the shape of the entrance from a circle to a rhomboid, for easier printing.

- Gear: No Changes
- Shaft: The shaft top was slightly pulled down so the propeller could exit the handle easier, once the stick is pulled.

NOTE: If there is anything that you fille like it can be improved, please don't hesitate to write a comment or message me.