Reed diffuser “sylvestris tree”
Sin soporte
Destacado
1,094
visitas
1
colección
0 comentarios
Cargando comentarios...
$4.00 Reed diffuser “sylvestris tree”
3D
Published 2024-04-11T09:35:46+00:00
3
0
Add to Collection
Descripción
Would you like to support my work? :)
Check out my full catalogue with exclusives, early access and commercial licences.
A reed diffuser based on a 3d scan of “pinus sylvestris” to be used with refill bags. The top and bottom align automatically with a notch.
Size assembled: 50 x 50 x 120 mm
Filling volume: 100ml
Detalles de impresión
- Important: Please make sure that any oil that your scent may contain is okay with the material of your print. Make sure that nothing in the product might be able to dissolve your print. For me PLA works just fine.
- Required build volume: 100 x 100 x 100 mm
- Material usage: 60 g
- Print direction: stls are rotated correctly, check images
- Support: none
- Nozzle size: 0,4 mm
- Line width: 0,4 mm
- Layer height 0,2 mm
- Outer walls: 3
- Infill: 15%
- Build plate adhesion type: none
- Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.
Información técnica
Date published | 11/04/2024 |
Precio | $4.00 |
Sin apoyo | YES |
Más información
Archivos