Replacement dishwasher cup shelf clip
Replacement dishwasher cup shelf clip
3D
Published 2018-01-22T15:30:43+00:00
This is a replacement retaining clip for the Cup Shelf p/n WD28X10180 for GE PDW7980N10SS and other similar dishwashers.
The clip snaps onto the outside frame of the shelf to hold it vertically when not in use.
The original clip was under-designed and is prone to breaking. Then the shelf just flops over and won't stay out of the way. With this clip, you don't have to buy an entire new cup shelf.
Openscad source code included for your modding emjoyment.
...
Version 1.1, 5/31/14 - Better fit, improved, larger hook.
Prints in a jiffy and requires no support.
Just print and snap onto any convenient bar on the cup shelf. ABS is recommended, or better yet, nylon.
I've included two small stabilizing pads since this part has a small contact area and is prone to popping off the bed before finishing. Just snip them off when done, or comment out that line in the source code if you do't want them. This way you don't have to enable raft in your slicer.
| Date published | 22/01/2018 |