Rubiks Void Part
1,205
visitas
22
descargas
0 comentarios
Cargando comentarios... 
Rubiks Void Part
3D
Published 2018-11-19T17:26:18+00:00
2
0
Add to Collection
Descripción
This is a very complicated part I broke on my Rubiks void cube. I was challenging to create in Fusion 360 but after 5 version I finally had one with tolerances tight enough to work. Because of the process of forming the original part there is a small hole in the bottom of the original part. 3D printing does not required this hole so this part should be stronger then the original.
I used a monoprice maker select to print this and used high density support under the arch because of the tolerance issue there was some post print clean up done with a knife to allow it to slide
Información técnica
| Date published | 19/11/2018 |
Más información
Archivos
