Simple Stand
Simple Stand
3D
Published 2018-01-15T16:57:05+00:00
This is my phone stand, there are many like it but this one is mine.
Benefits: very little materia, no supports, modify for wider|skinnier, taller|shorter just using asymetric slice scaling in a given dimension (z for hight etc...) vs 3d modeling. For example the one in the picture is squeezed from the file a bit as it was a touch to wide for portrait mode by default.
Have used it with phones and ipads with no issue. May make a taller base so that a cable can more easily run under to the rear if any are interested.
.3mm layers and pretty fast ~60mm a second. 215 first layer, 205 for the others. No supports. Example printed in PLA
Would look a lot cleaner with smaller layers... but if you are using it you don't see much of it.
If you go much wider than the initial file via scaling as mentioned in the description you might need supports.
| Date published | 15/01/2018 |
| ¿Cuándo tiempo lleva? | 180 - 240 minutos |
| Cantidad de filamento | ~35g @ 15% infill, 3 perimeters |
| Dimensiones | 100x70x65mm |
| Sin apoyo | YES |
