Snapmaker J1 XY belt calibrator STLs
Snapmaker J1 XY belt calibrator STLs
3D
Published 2024-02-23T15:51:52+00:00
This is a reverse engineered set of the XY belt calibrators for the Snapmaker J1.
Usually you will have these as a not permanently deletable gcode file in your printer. These ones here are only needed if you cannot use that file for some reason, e.g. because you do not have a 0.4mm nozzle or have exchanged the controller board for another one as I did.
Make sure to follow the printing instructions!
Print with PLA. Print settings need to be chosen in such a way that the bending bar of each part is massive.
The original Snapmaker code uses a 0.4mm nozzle, layer thickness 0.15 mm (1st layer 0.2mm), 4 perimeters, 4 top and 4 bottom layers and 15% grid infill in a 45° angle.
| Date published | 23/02/2024 |
| Sin apoyo | YES |
