Sovol SV01 Spool Roller Mod (Minimal Plastic, Easy Print)
Sovol SV01 Spool Roller Mod (Minimal Plastic, Easy Print)
Published 2021-01-22T10:24:55+00:00
Should work on any spool roller that matches the radius of the Sovol SV01. (Around 30mm diameter)
Plastic used: 12-15g
Print Time: 1:30 - 2 Hours
Current version uses 38 6mm BB's. (Airsoft bb's)
Notes:
Print it standing straight up.
Can be spiraled at lower layer heights.
Can be printed even as large as 3mm.
Make sure to use infill. For some reason printing it with 0 infill results in a weak and fragile shell. Even when maxed on walls. So add literally any additional infill. (I use only 4% gyroid infill)
But yeah. Print the tube. Slide it over. Then pop the bb's in. They may fall into the center but after you get a few in the ring, it'll hold it's distance. Real easy to pop out too. Just slip something between the bb's like a pencil and it'll pop right out.
Sovol Filament Roller Tube = The updated version. Slightly widened so it's easier to get on and off.
Sovol SV01 V1 = My previous version that sat closer to the OEM tube. Takes more effort to slide on.
Sovol Bearing Assist Plate = A Plate to make it easier to hold the tube level when inserting BB's. Entirely not necessary but it's there if you want it.
Despite the file orientation, Print it straight up. Rather than on it's side.
Date published | 22/01/2021 |
¿Cuándo tiempo lleva? | 90 - 120 minutos |
Cantidad de filamento | 15 |
Dimensiones | 80.9 x 44.1 x 44.1 |
Sin apoyo | YES |