Spool Holder for FlashForge Finder
5,220
visitas
436
descargas
1
colección
2 comentarios
Cargando comentarios...
Spool Holder for FlashForge Finder
3D
Published 2017-12-06T11:21:58+00:00
22
2
Add to Collection
Descripción
This is an auxillary spool holder I made for my FlashForge Finder to hold larger spools since the built in holder only fits rather small spools. This prints in 3 pieces and then you simply glue the pieces together with super glue or your preferred alternative. Supports/raft are not required, but might be needed depending on your print settings.
It is recommended to use this ONLY on the right side of the machine as you're facing it (as shown in pictures) as the print head can run into it on the left and front, and it does not fit on the back.
Información técnica
Date published | 06/12/2017 |
¿Cuándo tiempo lleva? | 556 - minutos |
Tecnología | FDM |
Complejidad | Fácil |
Sin apoyo | YES |
Más información
Archivos
Flashforge Inventor II / 13h / 60m filament / standard quality