Springo Tippi Tree Mod
Springo Tippi Tree Mod
3D
Published 2021-04-02T01:04:06+00:00
Make your Tippi Tree extra wacky with this Springo mod. Maximum wobble!!!
This part combines with the "Split Tree B.stl" part included with Tippi Tree (Folder:Tippi Tree>02.Printing Files>02.Extras>08.Split Tree>Split Tree B.stl)
Print Settings:
- 0.16mm layer height
- 3 shells/outlines
- 11% infill
- 8 bottom/6 top layers (make sure the coil part of the model is printed solid)
- No supports
Prints great in PLA. Other materials should also be fine but if the material cools too slowly it may become hard to separate the springo.
After Printing:
Carefully separate the layers of the springo with a butter knife, scraper, etc. Start at a corner and pry gently. After first separation it should come apart without much fuss. If layers are too stuck, you may be printing too hot, overextruding, or slicing incorrectly. You can test your settings with the much smaller Baby Springo.
Print Settings:
- 0.16mm layer height
- 3 shells/outlines
- 11% infill
- 8 bottom/6 top layers (make sure the coil part of the model is printed solid)
- No supports
- Prints great in PLA. Other materials should also be fine but if the material cools too slowly it may become hard to separate the springo.
After Printing:
Carefully separate the layers of the springo with a butter knife, scraper, etc. Start at a corner and pry gently. After first separation it should come apart without much fuss. If layers are too stuck, you may be printing too hot, overextruding, or slicing incorrectly. You can test your settings with the much smaller Baby Springo.
| Date published | 02/04/2021 |
| Sin apoyo | YES |
Springo Tippi Tree Tumbleweed Mod