Swarm (MiniMonsterMayhem Release)
13,644
visitas
68
colecciones
3 comentarios
Cargando comentarios...
$80.00 Swarm (MiniMonsterMayhem Release)
3D
Published 2023-05-09T08:56:36+00:00
182
3
Add to Collection
Descripción
-Support my Tribes and receive 40% off my entire MyMinifactory Library. CLICK HERE
-Join Tribes to get current months release for $10. CLICK HERE
RAW STL FILES CURRENTLY UPLOADED
LYCHEE AND SUPPORT STLS UPLOAD ON 5/8/2023
Información técnica
| Date published | 09/05/2023 |
| Precio | $80.00 |
| Sin apoyo | YES |
Más información
Archivos
I printed two models in this collection and they printed with no problem. The pre-support did not fail me. However, removing the supports on the lingering mass was a bit hard, maybe my exposition was too much (5 seconds), I will set it lower next time. The small Lingering mass's limbs are surprisingly solid. I was expecting them to be fragile but I was never in danger of breaking them while removing the supports. I broke off the two big front mandible while manipulating the model during assembly. So be careful with that. Also, the two pairs of arms did not fit perfectly in their slots. So I had to file them. The Hunter Devourer gave me absolutely no trouble what's so ever. I was expecting all the spikes on the model to be fragile but I never came close to break any of them while manipulating the model. The wings fitted perfectly inside the openings. I did not use the bases who come with the models and decide to use different ones. With the help of Microsoft 3D Builder, I took the top part of the base meant to be inserted under the models and made it longer to compensate for the absence of the rest of the base. Also, I used the substract mode to make a hole on the new bases that would fit perfectly with the rectangular shaped flyer stand. Unfortunately, the hole was not oriented properly so my Hunter does not face the front. I will pay more attention to that next time. Finally I think I should have made the Flying stand higher. The lingering mass almost did not fit, because one of his claw is low enough to touch the base. I do not regret to have subscribe to get these models. The miniatures are good looking and the pre-support files are working. Most of the struggles were my own fault.