TAZER!!! Pocket sized,18650 rechargable. High volatge. Micro USB.
TAZER!!! Pocket sized,18650 rechargable. High volatge. Micro USB.
3D
Published 2021-09-14T12:26:09+00:00
Super simple and compact tazer module.
Parts i used:
High voltage module: https://s.click.aliexpress.com/e/_dSZnwyn
Lithium charging board: https://s.click.aliexpress.com/e/_dXTpFtH
(Without the over current/overcharging protection)
I used m3 size screws:https://s.click.aliexpress.com/e/_d8whLxv
Trigger switch: https://s.click.aliexpress.com/e/_d60zjOR
(I used the 9mm tall one)
On off switch at the bottom: https://s.click.aliexpress.com/e/_d8SIkMR
Printed in ABS at 0.2mm layer hight.
You need to remove the plastic casing around the high voltage module to fit it in. Don't worry about braking it, it is fully incased in resin.
You can adjust the size of the spark by screwing in the prongs more or less.
Also you do not need over discharge protection on your lithium cell because the high voltage module stops working at about 3v.
This is a super compact design so the assembly is a bit difficult and also be careful about over heating, don't use it for longer than about a minute straight.
I'm not responsible for any damages :D also i suggest to not use the tazer around sensitive electronics.
12
0.2mm layer height
| Date published | 14/09/2021 |
| Sin apoyo | YES |