Textured Planter Series
Textured Planter Series
3D
Published 2023-02-20T17:01:25+00:00
These planters were designed after my recently released Fancy Easter Eggs. I really like the texture patterns I used on the Eggs and wanted to continue exploring more ways to use them! There are 3 Planters in this series; Diamond, Grid, and Web. They are all the same size (excluding thickness) and print with no supports needed. The planters have built in drainage holes, and I also designed and included a drip tray that works for each of the designs with raised ribs to facilitate water draining.
**This design is uploaded with a non-commercial license. Downloading this file does not grant you the right to sell commercially.
If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at
https://www.patreon.com/thinair3D
Printing Info:
**These are just the settings I used to test the model, feel free to use whatever settings work best for you.
- FDM or Resin: FDM or Resin. Resin may not be good for plants though
- Model Size: 102 mm x 102 mm x 70 mm
- Scaling: Scale up as you please. You can probably scale down but do with caution because wall thickness will become an issue at a certain point.
- Supports: None
- Infill/Perimeters: I just used 10% infill with 2 perimeters, but I would use extra perimeters for more strength.
- Nozzle Size: 0.4
- Layer Height: 0.2
Printing & Assembly
- No special instructions, just print and you're good to go.
- If you scale the planter, just scale the drip tray the same amount and they'll work fine together.
| Date published | 20/02/2023 |
| Sin apoyo | YES |