THE BU STIK FOR THE BAMBU LAB P1P
THE BU STIK FOR THE BAMBU LAB P1P
3D
Published 2023-04-24T10:56:48+00:00
The Bu Stik allows you to mount a variety of attachments to the top of the P1P including a phone mount and a container
Introducing The Bu Stik - a simple mod for your Bambu Lab P1P!
Explanation of the Files:
Bu Stik
You must print a Bu Stik for each accessory you add - the Bu Stick will require tapping into place, so you will not be able to remove it from the attachment.
Bu Cam
There are 12 versions of the Bu Cam available consisting of 2 sets. The Standard set is the one without the cutout to charge your phone while taking vertical video (see YouTube video). The Alternate (CUTOUT) set is the same as the Standard set but with a cutout in the part.
The name describes the dimensions of each STL. I recommend starting with the Bu_Cam_20mm_width_125_angle_40mm_slot if you have a case on your phone. The width of the gap for the phone in this file is 20mm set at a tilt of 125 degrees with a slot depth of 40mm. Use the 10mm version if you don't have a case on your phone.
If you would like to customize the parameters, please refer to the video. You need to have access to Fusion 360 to change the parameters.
Wyze Cam V3
Remote monitor your printer - only $35 with no subscription required!
https://amzn.to/3E30kbg
GoPro
Easily mount your GoPro using the standard thumscrew!
LED Light
Useful LED light that is a lot brighter than the stock LED light and has RGB!
https://amzn.to/40LO7Bs
Booster
Print this if you don't have a mod plate installed and are planning to print the Bu Cam - it makes a level area for the Bu Cam to sit on.
Container
You can adjust the text on this design by modifying the sketch within the Fusion 360 file.
RIP _____
You can display this if you wish.
Wedge
Print this to keep your phone secure.
Cable Management
https://www.printables.com/model/396083-bambu-lab-p1p-usb-cable-management-plate
Please review the YouTube video below for more information regarding changing the parameters and the design process. I would appreciate it if you would consider subscribing!
WATCH: https://youtu.be/YUm4lcdz16M
WATCH: https://youtu.be/Z2AcWHOvd7E
Connect with us in:
YouTube: https://www.youtube.com/@3dsourcerer
Website: https://3dsourcerer.com/
Facebook: https://www.facebook.com/3DSourcerer/
TikTok: https://www.tiktok.com/@3dsourcerer
Instagram: https://www.instagram.com/3dsourcerer
Twitter: https://twitter.com/3DSourceNews
LinkedIn: https://www.linkedin.com/showcase/3d-sourcerer
| Date published | 24/04/2023 |