Thumb Screw Cap for Hex Bolt
Thumb Screw Cap for Hex Bolt
3D
Published 2020-10-28T04:05:10+00:00
Made this simple cap to transform a basic hex bolt into a low profile thumb screw for an assembly I was designing.
Much more aethetically appealing and colour matched, its one of the little things that make the design look really clean and can be applied to tons of projects, so decided to share it by itself.
See the last photo for a sneak peak of the full assembly!(Hint: check out the logo)
The posted design is for either and M7 or 1/4" hex bolt (11mm wide hex).
I've secured mine with a bit of super glue, but it could be scaled down or up to be press fit. Also could play around with scaling to get it to fit different bolt sizes.
Printed on a Prusa MK2.5s in black PLA with a 0.8mm nozzle and 0.3mm layer height.
Probably would turn out better with a 0.4 nozzle and lower layer height, but I was rapidly protoyping and this turned out fine.
| Date published | 28/10/2020 |
| ¿Cuándo tiempo lleva? | 10 - minutos |
| Sin apoyo | YES |
