VOX Amplifier Corner Protector
VOX Amplifier Corner Protector
3D
Published 2018-10-17T15:12:11+00:00
Hello folks!
I modeled and printed this very useful spare part for VOX amplifiers.
This two-pin corner is found on most Vox amps starting in 1966 through 2004, excepting US Thomas Vox amps. This is the exact corner used on the Vox AC-30TB/TBX and AC-15TB/TBX. In fact, North Coast Music supplied these to Vox for the production of these amps! These corners were also installed on 1960s - 1970s Orange amplifiers.
These corners accommodate a 3/8" radius on the front edge, and a 3/4" radius on the front to rear edges of the amp cabinet.
Any doubt please let me know.
Hope you like it and print it!
No support needed.
Due to this is a crash/protective part, a filament with better resistance is recommended and with an infill above the 30%.
I printed it in PLA and PLA MAX with very good results, but probably ABS is better. Try your best and share results here. I read all the comments!
| Date published | 17/10/2018 |
| ¿Cuándo tiempo lleva? | 50 - minutos |
| Sin apoyo | YES |
