Wet Palette - CorgiCompact Hobby System
$4.95 Wet Palette - CorgiCompact Hobby System
Published 2024-03-13T11:01:25+00:00
Looking for a compact wet palette that integrates seamlessly into a broader solution for your hobbying on the go?
This listing includes the wet palette module, which consists of a lower reservoir, lid, and side clips. When clipped together, it serves to seal the moisture inside the palette so your paint mixes remain at the ready for a long session. This can be used as a standalone wet palette or integrated into any number of my other modules to create a custom travel hobby solution!
To get a reliable seal I recommend lightly adhering a rubber strip (I used cut up rubber bands and CA glue) to the top of the bottom piece. I have also included small reservoirs for copper alloy discs if desired. This design also accepts the RedGrass Games 180x130mm wet palette sponge and paper. You can use another slim sponge and parchment paper as well. See listing photos for more detail.
This design is not endorsed in any way by RedGrass Games.
I've designed this modular system for myself to solve the problem of either having to carry my full collection in a large case, or loosely (and unsecured) in something like a tote bag. All modules are stackable and include recesses to glue in 8mm diameter x 3mm thick magnets top further secure them into a single portable kit. Combine this module with any number of my other modules for infinite combinations!
Please check out my other designs as well!
Print in FDM at 0.2mm layer height. I print the top facing down so it does not require supports. The lower palette should be printed with the bottom facing down with supports enabled.
Be sure to use a large brim and a freshly cleaned build plate! These parts are large and flat so they like to curl up if your printer is not well optimized. I use a Bambu A1 and the textured PEI sheet at 50c to minimize warping.
These parts are approximately 215mm x 150mm so please ensure they will fit on your specific print bed.
I printed mine in PLA with 0.8mm walls and 10% infill.
Date published | 13/03/2024 |
Precio | $4.95 |
Dimensiones | 215mm x 150mm |