niklehmann's Print of Panther & Scout - Elf and Familar - 4 Models - PRESUPPORTED - 32mm Scale
Community Print Impresión 3D de Panther & Scout - Elf and Familar - 4 Models - PRESUPPORTED - 32mm Scale
Published 2020-03-22T11:47:51+00:00
1
3
Impreso con: Anycubic Photon
Material: Resin
Descripción
It look's just insane! Make sure you make custom supports! Because there are to many small details to handle for the software. I did it on ChiToBox. I scaled it up to 120% on my Anycubic Photon and mounted it on a PLA plate, because it would always fall and destroy the arrow. I could fix the arrow by dipping it in uncured resin and then holding it onto the broken point under the UV-lamp for 2-3minutes. I also used a ultrasonic cleaner but make sure you don't cure it to long in the cleaner, because that will damage the outer surface