nicwilson's Print of The Torture Toaster!
Community Print Impresión 3D de The Torture Toaster!
Published 2021-04-12T23:46:34+00:00
1
1
Impreso con: Creality CR-10 V2
Material: PLA
Descripción
Printed on a stock Creality CR10-V2 (except for BLtouch), using my own tuned firmware. All all works fine the only exception is the 0.1 slider is stuck, the other four slide freely, the gears move freely, the toast pops freely and the doors open and close easily. Layer lines are even and smooth and no stringing occurred at all, the overhangs did an excellent job even the 80 degree ones. Demonstrates what can be achieved without upgrades and when using a good tuned firmware.