CodyFlatla's Print of Light Me Up Lamp
Community Print Impresión 3D de Light Me Up Lamp
Published 2021-10-07T03:52:48+00:00
1
0
Impreso con: Creality CR-10 V2
Material: PLA
Descripción
I was able to get this to work after 4 attempts.
To get this to fit a Leviton lamp holder by printing it at 105% and then using a Dremel to enlarge the hole slightly.
Settings used: 6 top layers, 3 walls, 4 bottom layers, 0.2mm layer height, 0.4mm nozzle, 10% infill, 50mm/s print speed, 1.2mm z hop when retracted, tree supports, 75% overhang angle, 4mm brim.