Lotabeer's Print of Differential Gear
4,105
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Differential Gear
Published 2020-01-29T15:41:08+00:00
3
0
Impreso con: Prusa i3 MK3
Material: PETG
Descripción
Primarily printed in Atomic Filament CFPETG as a test. Had to re-print the pins later (in PCMAX because why not) because they didn't stick to the bed the first time. Printed everything without support and had a tiny bit of slop on the single bridge, as well as sag on the external rounded bits on the start of the housing, but nothing that affected function. The shafts were loose on press-fit, so I put a small piece of double sided tape on their square parts so that they will stay in place easier, but still be possible to take apart simply. I love this thing!