HottCheese's Print of Flexi Wallets
Community Print Impresión 3D de Flexi Wallets
Published 2020-09-02T02:09:06+00:00
3
0
Impreso con: Creality Ender 5
Material: Flexible
Descripción
Almost perfect, overall I'm extremely satisfied with the print and design, it does have a hard thick square layer on bottom that annoys me, I believe this may be due to my slicer settings. I may try adjusting some settings since I believe my default set to 3 bottoms layers.
I used 0% infil and 1 wall count with some generic tpu. I think it may be slightly better if the wallet was slimmed down to only have perimeters(no infil space) and then print it with a 2 wall count to increase strength.
The 2nd card pocket also goes to the bottom of the wallet which could be annoying when in use, a wall could probably be added to allow for a bottom to be made in the pocket.