gestolh's Print of Large Pendulum Wall Clock
Community Print Impresión 3D de Large Pendulum Wall Clock
Published 2020-11-09T11:40:10+00:00
2
5
Impreso con: Creality Ender 3 Pro
Material: PLA
Descripción
My remarks
- After minor adjustments it worked as soon as it was hanged .
- It works non-stop till the weight reaches the floor.
- It is very slow looses 15 min every hour.
- Pendulum shaft is a 100cm x 7mm brass tune.
- Weight is an old paper mill filled with gunshot 1250gr.
- I printed the “ Front Frame Lower” without the numbers and printed different faces so that I can change them from time to time.
- I studied your instructions about the “ Hour-Minute” assembly very carefully but could not make it work.In the end I glued misc spacer 4 to gear 4b 18 ,the hour/min hands move but I cannot change the time.
Any help highly appreciated.
Giorgos Stolis