liudas's Print of Large Pendulum Wall Clock
Community Print Impresión 3D de Large Pendulum Wall Clock
Published 2024-03-10T09:06:03+00:00
0
1
Impreso con: Anycubic
Material: PETG
Descripción
Hello,This is my build. In this photo string is too thick, later I replaced it. Hands and Dial glow in the dark. Small metric screws are 3x12 and 3x20, I used T10. While adjusting I noticed that full cycle of pendulum is 1.5 seconds and it disturbs me a bit.Can you make upgrade of pallet and escapement that pendulum cycle would last 2.0 seconds? I understand that I may need longer pendulum, but since I started from longest possible configuration my clock was already running approximately 1.5 times slower :)And I would highly recommend you to group parts in archive in sections like: Body, Gears, Pendulum, Accessories.P.S. adjusting for beginners: long pendulum - slow speed, short pendulum - fast speed.