capfive's Print of Nakatomi Plaza - From "Die Hard"
Community Print Impresión 3D de Nakatomi Plaza - From "Die Hard"
Published 2020-10-29T22:44:55+00:00
2
0
Material: PLA
Descripción
Now I have a Nakatomi Plaza... Ho-Ho-Ho!
Printed on JGAurora A5S (with Pinches Community Firmware)
Slicer: Cura 4.7.1
Model Height: 150mm (6in)
Filament: Inland Gray PLA
Extruder Temp: 215
Nozzle: 0.4mm
Bed Temp: 65
Layer Height: 0.2mm
Wall Thickness: 1.0mm
Wall Count: 2
Infill: 5%
Print Speed: 80mm/s
Supports: none
Plate/Bed Adhesion: Brim (Left on by accident. Should print well without it.)
Total Print Time: 5h 51m 3s