prestonphillips's Print of Racing Skiff - 3 Pack
Community Print Impresión 3D de Racing Skiff - 3 Pack
Published 2022-03-08T15:07:02+00:00
2
0
Material: PLA
Descripción
This was printed on the Anycubic Vyper in PLA.
After printing out the full scale version, I wanted to see if it was possible to go smaller with the intention of running a game at ~12mm scale. I know the details are difficult to show un-primed, but it's been raining here.
I included a standard 28mm mini next to the ship in the second shot to give an idea of the size. The last shot shows the ship with the same mini at half scale.
Note: The supports at half scale (full model printed at once) are a bit tough to remove, but once you get them going they eventually come off in a clump.
Settings:
Print Time - 7 Hours
Layer Height - .2mm
Infill Density - 15% (Grid)
Speed - 60mm/s
Bed Temp - 60 C
Hot End - 210 C
Supports - Auto Generated