Drogna's Print of Undead Dragon Climbing
489
visitas
2 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Undead Dragon Climbing
Published 2022-06-26T16:15:43+00:00
2
2
Material: Resin
Descripción
Printed on a Creality LD-002H (MMF never has it on the printer list).
I found it pretty hard getting the dragon to stand on the base. I tried just using resin but either it was not enough or my bottle was a little expired. Either way, I wasn't getting a strong enough bond even after scoring the contact surfaces. I pinned the middle foot since you can easily pin up through the leg. The other two are a combination of heavy duty double sided tape and superglue.