LetsPrint's Print of Zelda: Breath of the Wild: 3D Printed Goddess Statue
Community Print Impresión 3D de Zelda: Breath of the Wild: 3D Printed Goddess Statue
Published 2017-05-03T13:49:31+00:00
5
0
Impreso con: Prusa I3 Geeetech
Material: PLA
Descripción
Printed a decent size of this amazing statue on my Prusa i3. Took a little over 17 hours due to the size; which was around 130mm wide x 100mm long x by 165mm Tall..ish) Not exact measurements, but definitely most of the bed lol.
My Settings:
.2mm Layer Height
10% Infill
5 Top Shells/5 Side Shells/ 3 Bottom Shells