MagnusNico's Print of Clairiel, Angel of Resurrection
Community Print Impresión 3D de Clairiel, Angel of Resurrection
Published 2021-07-13T22:59:14+00:00
2
2
Impreso con: ELEGOO Mars Pro UV Photocuring LCD 3D Printer
Material: Resin
Descripción
Hello! Could Heroes Infinite / Raging Heroes tell me about the way to set Clairiel on her base like in the concept, please?I managed to successfully print her, and would like to offer her as a gift to a loved one.
Unfortunately, none of the glues I use allows her to stay this way (and I fear breaking her standing wing in the long way).
Any suggestion would be appreciated. Many thanks!
Also, here are a couple comments/suggestions to print her successfuly:
- With ChituBox, the model flies high above the platform: lower the miniature to height 0, and set a solid skate-shaped raft. Delete any additional support added with this operation (the miniature comes with a bazillion supports anyway).
- As soon as the miniature is cleaned, but before the UV, cut VERY carefully the supports to the hands, feet, and to the star flying above the angel. These are the most fragile points on the mini.
- After the UV treatment, remove the support using cutting pliers and a tweezer. Don't be afraid to cut the support into a million pieces, and fully remove the draft as soon as possible. From then on, you'll be able to peel through the supports and pull slowly the tiniest ones from below.
Make sure to study the piece before starting, as it's easy to miss small details, intertwined limbs, and draped clothes.
It took me five tries to reach success.
Removing the pre-supported supports took me basically three hours (but I'm a beginner).