Blackraven6's Print of Bounty Hunter 75mm
271
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Bounty Hunter 75mm
Published 2022-06-19T11:34:52+00:00
0
0
Impreso con: Anycubic Photon
Material: Resin
Descripción
Used this model as a first testing print instead of the stock model as I saw in one video that it already comes ready to print with a lot of details. Printed on Anycubic Photon Mono 4K, basic anycubic grey resin, 65% lamp power, 0,020 layer, 7 sec exposure, 12 hours of print, no smoothing or anti-aliasing. I think 7 seconds was a bit too much, I'd prefer a bit easier detach. I think it got quite decent.
PS chitubox shitted the bed trying to save this for printing for more than half an hour, so I used stock Photon Workshop 64 and it did quite good.