maximehemion's Print of Hero Wizard (2 Versions)
Community Print Impresión 3D de Hero Wizard (2 Versions)
Published 2024-03-02T12:38:37+00:00
1
1
Impreso con: Anycubic Photon Mono X 6K
Material: Resin
Descripción
Poor Li Ming, out of the batch this one had the most issues.
First the crown broke, I don't know exactly when, but the thin part of each spike was just too fragile and did not manipulate it with enought precaution
Then the face was very clogged by primer, and I don't like my fix as much as the DH (I probably should have used IPA to clean it & start over )
On a sidenote I tried to make pink gemstones with ... moderate success.