10mm Hold for Hangboard and Climbing
69
views
3
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
10mm Hold for Hangboard and Climbing
3D
Published 2024-02-21T15:41:08+00:00
0
0
Add to Collection
Description
A 10mm edge/hold for mounting to a DIY home hangboard. One edge is flat, with the opposite having a slight concave for easier grip.
The edge is mounted to the board using 25mm M8 bolts, a 20mm washer which attaches into a M8 T-Nut on the other side of the board. If you would like an alternate attachemnt method, message me.
Licence
Détail de l'impression
Printed using 4 walls with a 0.28mm layer height and 30% infill.
The Fuzzy Skin mode was used in Cura to give extra grip, but this can also be achieved with rough sandpaper.
Technical Information
Date de publication | 21/02/2024 |
Sans support | YES |
More Information
Object Parts